Eclipse 400 70mm EDF Park Jet MikeysRC
Plane Electronics Requirements
70MM EDF with servos and ESC
1 — 14.8V 1800 -2200mAh 25C li-po battery.
1 — 70MM ducted fan (or good quality 64MM fans and motors might work)
1 — 60 amp speed control (or 40 amp ESC if you try using a 64MM EDF).
4 — 9 gram servos or 4
3/16th or 1/4 inch Foamboard for the fuselage, wings and tail. I highly
reccomend using foamboard from the Dollar Tree stores as it’s 1/2 the weight
of other foam board and just about as strong. About 3, 20 X 30 inch sheets of board are needed.
The company that makes this foam board is http://www.adamsplasticsinc.com/
1/16 galvanized steel on a roll (from a hardware store) or RC pushrods, about 14 inches are needed OR you can use RC pushrods if you have them.
Hot glue(prefered) or 5 min epoxy.
Thick packing tape for control surface hinges and wing stiffening.
About 40 inches of 5/16 inch diameter wooden dowel for the wing spar.
6 regular size popsicle sticks.
About 6 tounge depressors.
You may need to add 50-70 grams to the nose to balance with 1800mah battery for the Eclipse 400.
QX-Motor 70mm 6 Blades