Added by: RC Plane PosterType: electro, parkflyer, deltaAutor: drcameronWingspan: 400Flying Weight: Not InformationDownload Free Plans RC Model (168)Rewiev:
This wings is designed using TinkerCAD. The purpose is to use them for a micro RC flying wing.
The assembled wing is 40cm (400mm). I was able to print each wing diagonally on my Monoprice Maker Select 3d v2.1 printer that has a 200mm build plate. I covered the wings with packing tape and used foam plates to cut out winglets that I drew freehand.
The CG is just behind the box that holds the receiver brick.
- Printer: Monoprice Maker Select v2.1
- Rafts: No
- Supports: No
- Resolution: .2
- Infill: 5%
Printed with 2 walls (.4mm) and ZERO top and bottom layers. For infill I used a grid pattern in Cura. This is what generates the wing structure.The wings should be oriented on the plate the same for each wing, though a reverse orientations should be fine too. This helps the grids to line up when assembling the wings.
Racerstar Racing Edition 1306